Replacing A Fence Post

By El Camino Rental Posted August 12, 2015 In Design

Replacing A Fence Post

Wooden fences often last at least 20 years, but they begin to rot over time. When they do, they normally break. Even new wooden fences can break within a strong storm or during accidents, and a broken fence can be impossible to repair. When this happens, the fence must be replaced. Replacing an old fence for a new one may require work, but it doesn’t require special tools or skills. A strong work ethic and a little creativity will suffice -Replacing a Fence Post.

Replacing a fence requires the individual to detach the old fence from both sides of a broken post. Then, once the broken post is removed, re-installation begins and reattachment follows. Those with broken fences will require a few supplies before beginning work. Remember, removing an old fence pot will require physical labor, so individuals are warned to be prepared -Replacing a Fence Post.

A replacement fence post will be needed, and a nail puller, crow bar and scrap wood will also be needed. A reciprocating saw may be useful, and a post-hole digger, a shovel and bracing two-by-fours will be required. Concrete and galvanized nails and screws will also be needed for the reconstruction process.

Disconnect the fence from both sides using the reciprocating saw while removing its screws and nails. Once the post has been freed, swing its sections a foot away from the post to make room. Each loose end should be braced with two-by-fours while work is commenced. If posts are set in concrete, dig away at the soil atop the concrete; sometimes, posts may be lifted from concrete when tugged. This leaves a hole for a new post.

Break away any exposed concrete with a sledgehammer, and remove the concrete base with the old post. Then, make sure the remaining hole is at least 36 inches deep. Insert a concrete form and pack it with dirt extracted from the hole. Utilize a shovel to empty 6 inches of gravel into the concrete form’s bottom, and stand the post upwards within the tube.

Mix a bag of quick-set concrete, and pour it into the hole. Utilize a level to ensure the new post’s straightness, and brace it into position. Let the post dry overnight. Remove the braces on the following day, and re-attach fallen fence sections to the newly-installed post. Finish replacing the broken fence post by lengthening the new post’s top. Make sure it’s similar to the old post’s height.

LEAVE A COMMENT